- Posts: 113
- Thank you received: 45
Journal: 1968 Commando tear down/rebuild PART 4
- commando6868
-
Topic Author
- Offline
- Premium Member
-
Less
More
10 years 5 months ago - 10 years 5 months ago #461
by commando6868

Well, all needed new parts are on hand, New "Superblend, C3 clearance bearings" installed on both sides. Crank was bolted together, barrels have been bored and cleaned, new rings and pistons, crank turned, etc.
The cases were heated in the oven and the new bearings inserted, and the pressed on the crank. After everything cooled the cases were joined with the crank inserted and the end play measured. all within tolerances.
More to come
"THE FUTURE'S UNCERTAIN AND THE END IS ALWAYS NEAR"
Journal: 1968 Commando tear down/rebuild PART 4 was created by commando6868
Well, all needed new parts are on hand, New "Superblend, C3 clearance bearings" installed on both sides. Crank was bolted together, barrels have been bored and cleaned, new rings and pistons, crank turned, etc.
The cases were heated in the oven and the new bearings inserted, and the pressed on the crank. After everything cooled the cases were joined with the crank inserted and the end play measured. all within tolerances.
More to come
"THE FUTURE'S UNCERTAIN AND THE END IS ALWAYS NEAR"
Last edit: 10 years 5 months ago by commando6868.
Please Log in to join the conversation.
Time to create page: 0.054 seconds
Copyright © 2026 NNENO.org - Produced by Media Guys dot com