- Posts: 42
- Thank you received: 12
head gasket
- gocommando
-
Topic Author
- Offline
- Senior Member
-
Less
More
9 years 6 months ago #702
by gocommando
head gasket was created by gocommando
changing out weeping (copper) head gasket, going with composite flame ring. read may variations on line - any one have luck with some liquid gasket around push rod holes? coat one or both sides ? please chime in with your thoughts/advice. thanks,JS
Please Log in to join the conversation.
9 years 6 months ago - 9 years 6 months ago #704
by dynodave
Dave Comeau
atlanticgreen.com/contact.htm
Replied by dynodave on topic head gasket
I've mostly used 518 loctite know as purple jelly, both side of gasket, Around the push rod tunnels and around the drain back hole.
Failure to really clean the gasket surfaces of head and barrel reduces effectiveness. Ask Mike Friel about cleanliness
.
Hope you know and use the correct tightening /torquing sequence.
Failure to really clean the gasket surfaces of head and barrel reduces effectiveness. Ask Mike Friel about cleanliness
Hope you know and use the correct tightening /torquing sequence.
Dave Comeau
atlanticgreen.com/contact.htm
Last edit: 9 years 6 months ago by dynodave.
Please Log in to join the conversation.
- gocommando
-
Topic Author
- Offline
- Senior Member
-
Less
More
- Posts: 42
- Thank you received: 12
9 years 6 months ago #705
by gocommando
Replied by gocommando on topic head gasket
thanks Dave
Please Log in to join the conversation.
Time to create page: 0.035 seconds
Copyright © 2026 NNENO.org - Produced by Media Guys dot com