horn

More
9 years 6 months ago #716 by gocommando
horn was created by gocommando
so last month after brief winter nap my 75 fired right up. took it for inspection stickah - everything worked but horn-just a mild chirp. was given a sticker after promising to fix. searched through spare parts bin and found a working donor with 2 terminals. was able to disconnect original wires (striped purple and red I think). I've replaced horns before-disconnect ,unbolt...bolt, reconnect - but concerned about positive ground set up - don't want to fry any wires. can i just hook up original wires ? also can i mount new horn directly to steel frame without issues? advice please.

Please Log in to join the conversation.

More
9 years 6 months ago #717 by dynodave
Replied by dynodave on topic horn
Horns are not polarity sensitive. The correct and easiest way is to pull the rear fender. It is actually the quickest and least stressful. Most horns can not be rigid mounted successfully.The horn MUST use the (flexible) mounting bar or it will not oscillate (beep) strongly.

Please Log in to join the conversation.

More
9 years 6 months ago #718 by gocommando
Replied by gocommando on topic horn
dave i should have been clearer. the issue I was concerned with is more electrical in nature. does the horn need to be insulated from the steel frame so that it doesn't beep when power is on. years ago i replaced pair of horns - i had one set that when mounted in stock location on frame beeped when ignition was on. another set had no issues with mounting to frame. and i am using a more forward and accessible location on my Norton. thanks

Please Log in to join the conversation.

More
9 years 6 months ago - 9 years 6 months ago #719 by dynodave
Replied by dynodave on topic horn
An electromagnetic horn is not polarity sensitive. an air horn compressor with motor very likely is...
If you're moving the horn then your new modified wiring needs to be correct. If you don't know what is the operating principal of the horn and wiring is,.. then you need educated help or else trial and error until you luck out upon it.
You can call or come down if you want, sorry but it's more than I want to type :(
could be a tech session?
Last edit: 9 years 6 months ago by dynodave.
The following user(s) said Thank You: Bthor77

Please Log in to join the conversation.

More
9 years 6 months ago #720 by gocommando
Replied by gocommando on topic horn
thanks...as stated did horns in past but on neg ground systems-didn't know if it made a difference. sure i'll get it done.

Please Log in to join the conversation.

More
9 years 5 months ago #725 by gocommando
Replied by gocommando on topic horn
so i found a small horn...2.5" 12v 2 terminal 1.5 amp with a simple steel strap bracket. put a small bend in bracket and attached to frame behind the left side cover. i wrapped frame with piece of bicycle inner tube and used a hose clamp to attach bracket and horn. used existing stock wires- only worked one way so not sure if this is what Dave meant by polarity sensitive but beeps fine and quicker fix than diving into the original location.

Please Log in to join the conversation.

Time to create page: 0.066 seconds